IMPORTANT! PROBLEMS?
Before taking Crash Force™ Regenerator™ RC
back to the retailer, call our friendly
RC technicians at: 1-800-622-8339
STORAGE: The Crash Force™ Regenerator™
RC should be stored indoors in the box and
foam tray after each use.
After
Impact!
CRASH FORCE™
REGENERATOR SUV™
BATTERY INSTALLATION
Crash Force™ Regenerator™ is designed to work with standard RC 6-Volt NiCad batteries and charger,
sold separately. If you do not have a 6-Volt battery and charger, Crash Force™ Regenerator™ can operate with
Five-AA batteries. • Controller is designed to work with a 9-Volt battery, sold separately.
INSTALLING BATTERIES IN THE REGENERATOR™
compartment, making
sure to follow the
6 VOLT
Battery
1 - To install the
6-Volt battery, rotate
the door locks to the
sides of the battery
compartment door
as shown.
correct + and –
Turn
Vehicle
Over
Compartment
Door
2
polarity markings.
Then fold the internal
battery adjuster out,
to hold the 6-Volt
battery in tight.
6-V
Battery
1
3
Lock
Battery
Compartment
2 - Remove the battery 4 - Replace the battery
Battery
Compartment
Door
compartment door.
3 - Place the battery
in the battery
compartment door and
rotate the door locks
to their “Lock” positions.
Lock
3 - Place the batteries
in the battery tray
AA BATTERIES
1 - To install the AA
according to the + and
– polarity markings.
2
Turn
Vehicle
Over
batteries, rotate the
Battery
Compartment
Door
door locks to the sides 4 - Place the battery
of the door as shown.
2 - Remove the battery
compartment door
and make sure the
internal battery
tray into the battery
compartment.
5 - Replace the battery
compartment door and
rotate the door locks
to their “Lock” positions.
1
Lock
Five-AA
Battery
Compartment
Door
Batteries
Lock
adjuster is folded in,
out of the way.
3
Battery
Tray
Phillips Screw
Battery
INSTALLING CONTROLLER
1
9 VOLT BATTERY
4
Compartment
Door
1 - Using a Phillips screwdriver, undo the
hold down screw and remove the battery
compartment door.
9-V
Battery
2
2 - Place the 9-Volt battery in the battery
compartment, making sure to follow the
correct + and – polarity markings.
3 - Replace the battery compartment door
and refasten the hold down screw.
3
Battery
Compartment
Battery
Compartment
|